What is in this article?:
- Cover crop mixtures require properly calibrated grain drill
- Mark with chalk, use valve stem
• Calibrating your grain drill is the only way to avoid over- or under-seeding your fields.
• Grain drill calibration is not too difficult and should only take you a half hour or so.
Mark with chalk, use valve stem
• Next mark the tire with chalk (or use the valve stem), do this in the field preferably with the drill in the ground to account for slip, count the number of drive tire revolutions in the measured distance. Ex. We counted 19 revolutions on the drive wheel in 145.2 feet.
• Next, park the drill, either jack up the drive tire or block up the drive wheel so you can turn it by hand.
• Weigh one container and write down its weight or tare the scale. Ex. Empty container weight = 1 pound.
• Remove ¼ of the seed tubes from the disk openers and place the ends of them in buckets to collect the seed. Ex. In our case this was 6 of the 24 seed tubes, you can do 2 seed meters side by side into one container and use 3 containers to catch 6 tubes.
• Put seed in the drill, you only need enough to cover the rows that you are collecting from.
• Turn the drive wheel a few times until the seed fills the meter and comes out the tube.
• Empty your containers.
• Turn the drive wheel the number of turns needed to go the distance measured earlier equaling 1/20th of an acre. Ex. 19 turns.
• Combine all the seed together in the one bucket and weigh. Ex. 1.20 pounds — 1.00 pounds = 0.20 pounds of seed.
• Then multiply the amount of seed collected by 4 since you only collected from 1/4th of the drill. Ex. 0.20 X 4=0.80 pounds.
• Then multiply that number by 20 since you only did 1/20th of an acre. Ex. 0.80 x 20=16.0 pounds per acre (this is less than our desired 20 pounds per acre, but sufficient enough to plant the field). That final number is the pounds of seed that will be planted in an acre.
• Repeat this process 2 more times and see that it is consistent.
What we should have done was to look at the seed chart first then put the annual ryegrass in the main box and the crimson clover in the small seed box and calibrate them separately to achieve the desired rate of each.
You can use this method for small grains, grass seed, soybeans or anything else you plant with your grain drill.
Write down this information in your owner’s manual so next season you will know what setting you used and if you want to calibrate your drill again with another crops you will already have the distance measured out.
For more information on drill calibration go to http://www.ces.purdue.edu/extmedia/ABE/ABE-126-W.pdf.