What is in this article?:
- Large-seeded runners: Lime at planting, gypsum at bloom
- Yield increase
• Research from 2008-2010 showed that both the 500 pounds of calcium per acre in the pegging zone requirement and the 1,000 pounds of gypsum per acre overall appears to hold for large-seeded runners, and especially for Georgia-06G.
• Also, when the pegging zone calcium is between 500 and 750 pounds per acre, you are in a ‘grey area,’ and this is where calcium chloride or calcium thisosulfate applied through center pivots may be most beneficial.
CALCIUM RECOMMENDATIONS FOR peanut production haven’t changed significantly with the increase to large-seeded varieties, but calcium remains critical to seed germination.
While peanut production has shifted in recent years from small-seeded to large-seeded runner varieties, calcium recommendations haven’t changed as drastically, says Glen Harris, University of Georgia soil scientist.
“Technically, the calcium recommendations haven’t changed,” says Harris.
“Research from 2008-2010 showed that both the 500 pounds of calcium per acre in the pegging zone requirement and the 1,000 pounds of gypsum per acre overall appears to hold for large-seeded runners, and especially for Georgia-06G.
“Also, when the pegging zone calcium is between 500 and 750 pounds per acre, you are in a ‘grey area,’ and this is where calcium chloride or calcium thisosulfate applied through center pivots may be most beneficial.”
The research — conducted over 11 sites — actually found that yields decreased when the rates were bumped to 1,500 pounds per acre, he says.
The rules for calcium in peanuts remain relatively simple — lime at planting, gypsum at bloom time, says Harris.
“We do it this way because the calcium in lime is not as soluble as the calcium in gypsum, and it needs time to get into the pegging zone and into the nut,” he says.
Original recommendations for providing calcium to the pegging zone called for 1,000 pounds of gypsum or the equivalent (broadcast or banded) at bloom time.
And this was to be applied only if you did not have at least 500 pounds of calcium per acre and a calcium/potassium ration of at least 3:1 in a soil sample taken from the pegging zone soon after the peanuts emerge.
Since calcium is critical to germination, it always has been recommended that any peanut being produced for seed should receive 1,000 pounds of gypsum at early bloom regardless of pegging zone calcium and potassium levels, says Harris.
Research was done about 15 years ago at the University of Georgia using lime at planting to provide calcium to the pegging zone of peanuts.
This method should be used only when lime is recommended according to soil sample results. If lime is used when it isn’t required, it can raise the pH above recommended levels and cause micronutrient deficiencies such as with manganese, he says.
“Also, if you use lime, it should be applied at planting and should not be deep turned. This will allow time for it to break down and be absorbed into the developing nuts.”
Over the past three years, university researchers have tested using liquid calcium chloride or calcium thiosulfate through the pivot during peak pod fill, says Harris.
“This has shown promise for providing calcium to the pegging zone. If gypsum is in short supply, this could be a valuable alternative. Calcium chloride also has been tested in dryland situations by applying in a band behind the presswheel at planting.”